Pay rate: $22.82
Site location: 3737 Dan Morton dr, Dallas, TX
Shift options: 2nd- 2pm-10pm ; 3rd- 10pm-6am ; 6pm-6am
Summary
Operates stacker controls to ensure stacks are aligned and orderly. Prepares stacked units for banding, operates palletizing machinery and ensures quality of product. Performs all duties in a safe manner, while wearing all required PPE and immediately reports any safety concern to the supervisor.
Major Responsibilities
- Visually inspects each unit for defects (bad knifes, wrinkles, warp, out of line, proper pad placement, loose liner, unit appearance, etc.).
- Units found to be defective must have defective material removed.
- Informs knife man of the amount of defective board so the amount can be rescheduled to run.
- Measures at least one sheet from each order for length, width, and scoring accuracy. Issues regarding quality are to be brought immediately to the knife man or supervisor’s attention.
- Reads production orders to ensure all special instructions are being fulfilled (units with specific height requirements, or that require exact quantities per unit, full pad protection, cross-banded, etc.).
- Monitors alignment of board and manipulates controls to ensure proper alignment of stacks. • Understands and utilizes proper procedures for knife exit section controls and lift positioning controls.
- Places tie sheets in multiple stacks, inserts proper pads or cross-pads to units when necessary.
- Operates the palletizing machinery and inspects units to ensure plastic bands are applied securely to each bale prior to shipment. • Communicates any special situations to the individual who is relieving them.
- Responsible for keeping area and equipment clean of any debris or scrap material.
- Attends all safety training provided by the employer.
Education and Experience:
High school diploma or equivalent; or up to one month related experience; or equivalent combination of training and experience.
- Knowledge and Skills:
- Ability to add, subtract, multiply and divide using whole numbers, common fractions and decimals.
- Ability to read a tape measure to within 1/16th of an inch.